Maple Airsoft Supply SuperFeed Series High Speed Replacement Magazine Springs (GEN 3) (Pack of 3) Reviews

4.7 Rating 34 Reviews

Maple Airsoft Supply’s SuperFeed series replacement high speed magazine springs are perfect match for AEG, GBB, and PTW platforms. These updated Generation 3 springs are extra long and have improved heat treating to help retain their shape and avoid being crushed under their own weight.
SuperFeed springs use a superior one piece design to decrease the chance of jamming and increase reliability. Competitor’s replacement springs use a two piece design which can be detrimental to the magazine.
Made from high tension heat treated spring steel, SuperFeed springs are perfect for high ROF builds as well as Snipers or Designated Marksmen who wish to reliably use heavy weight bbs.
Installation is easy. Most magazines can be done in a couple minutes. Each mag uses 1 spring.
Compatible with most AEG and GBB magazines. Simply cut to desired length and install.

Visit Product Page

“Thick metal gives great tension and looks like itll hold up for a long time. Perfect fix to my problematic midcaps.”

Helpful Report

Posted 5 years ago

“I have used the maple over 30 of these springs coupled with the hexmag followers to fix horrible mags issues. in each mag that i put these in I am able to feed .5g bb with ease and they feed .4 like it is nothing. really good investment if you are stuck with a horrible proprietary mags that some airsoft gun are known for used these in VFC scar H, VFC 417, PTS mags, G&P sr25 mags, and A&K sr25 mags. The only mags where i didn't use the hexmag followers is on the PTS epms.”

Helpful Report

Posted 5 years ago

“Had 6x G&G 120rd mid cap mags, which had troubles feeding 0.45g BBs in my DMR. These springs made a huge difference! BBs are flying out of mag with lightning speed and had no issues since then.”

Helpful Report

Posted 5 years ago

“So I have 3 vfc hk417 7.62 mid cap mags and was having feeding issues..tire everything down and so on and the dang fix was Maple airsoft super feed springs! INSTALLING THESE MADE THE MAG HOW IT SHOULD HAVE COME FROM THE FACTORY ...looking at you Vfc”

Helpful Report

Posted 5 years ago

“They are so stiff my Odin speedloader will only load about half the mag I have to use a normal one to fully load them”

Helpful Report

Posted 6 years ago

“These are spectacular replacements for stock springs that are only meant to push .20g BBs. I used these for my KWA RM4 Ronin 3.0 120 mags. After the initial installation, I found that the springs were binding at 90 rounds causing some issues, so I just clipped 1" off the end and that seems to be the perfect application for my magazines in particular. I have put about 7000 rounds through 10 separate magazines and all is great!”

Helpful Report

Posted 6 years ago

“Good length, would be great to have factory measurements of how long the springs should be to help install. but worked great,”

Helpful Report

Posted 6 years ago

“These springs are very good quality however, they only fit on followers that have the large end on them. The Followers in my Echo 1 AK mags have a small end where the spring attaches. It's too bad Maple Airsoft did not make their springs with one "small" end an one "regular" end since you have to cut them to length anyway. I also believe most feeding problems are cause by the poor quality of the follower and not weak springs.”

Helpful Report

Posted 6 years ago