Maple Airsoft Supply SuperFeed Series High Speed Replacement Magazine Springs (GEN 3) (Pack of 3) Reviews

4.7 Rating 35 Reviews

Maple Airsoft Supply’s SuperFeed series replacement high speed magazine springs are perfect match for AEG, GBB, and PTW platforms. These updated Generation 3 springs are extra long and have improved heat treating to help retain their shape and avoid being crushed under their own weight.
SuperFeed springs use a superior one piece design to decrease the chance of jamming and increase reliability. Competitor’s replacement springs use a two piece design which can be detrimental to the magazine.
Made from high tension heat treated spring steel, SuperFeed springs are perfect for high ROF builds as well as Snipers or Designated Marksmen who wish to reliably use heavy weight bbs.
Installation is easy. Most magazines can be done in a couple minutes. Each mag uses 1 spring.
Compatible with most AEG and GBB magazines. Simply cut to desired length and install.

Visit Product Page

“These springs are very good quality however, they only fit on followers that have the large end on them. The Followers in my Echo 1 AK mags have a small end where the spring attaches. It's too bad Maple Airsoft did not make their springs with one "small" end an one "regular" end since you have to cut them to length anyway. I also believe most feeding problems are cause by the poor quality of the follower and not weak springs.”

Helpful Report

Posted 6 years ago

“Great springs. Stiff one piece. Buy extra I messed up and cut two too short for my ak mid caps.”

Helpful Report

Posted 6 years ago

“The Maple replacement springs are outstanding in quality and performance. The initial installation is a bit difficult until you figure out a system to feed the spring in its entirety in the magazine. My. single complaint is that after the installation the magazines now hold a maximum of 60 rounds due to the extra length of the replacements.”

Helpful Report

Posted 6 years ago

“Recently installed in my G&P mid caps and I believe the design is meant to fit a BAMF mag and trip for smaller capacity mags so they can be fit into all mags with trimming, fead flawlessly and would buy them all again”

Helpful Report

Posted 7 years ago

Christopher S

Verified Reviewer

“Great Product, but a pain to install”

Helpful Report

Posted 7 years ago

“I used MAG upgrade springs and had jams. Decided to give these a try and will be upgrading all my mags to Superfeed.”

Helpful Report

Posted 8 years ago

“Just replaced my g&p sr25 spring with the maple leaf aeg spring and it made a huge difference.”

Helpful Report

Posted 8 years ago

“Super quality springs, somewhat annoying to install at first, but after they were in the mags fed perfectly. Buying more for the PTW”

Helpful Report

Posted 8 years ago