Bridge White Reviews

4.9 Rating 26 Reviews

About Flair.co:

We founded Flair to solve a problem that almost every house or apartment has: the room that doesn't heat or cool evenly. Its temperature is out of sync with the rest of the house. It's either too hot or too cold.

Flair fixes that. We built a suite of products that give you room-level temperature control at an affordable cost.

We want you to be comfortable and to save energy. It's as simple as that.

Visit Product Page

“It was easy to set up and it has excellent range. I have a two-story house and the signal was good for the upper level.”

1 Helpful Report

Posted 5 months ago

Author didn't leave any comments.

Helpful Report

Posted 5 months ago

“We have 11 flair vents in our home and they were connected through the flair pucks (gateway mode), the vents work great but the signal was weak with some of the vents. The bridge has greatly improved the connectivity and solved the problem of weak signal. It was very easy to set up the bridge (2 minutes or so) and then the bridge went into network repair mode for about 30 mins and automatically found and connected all vents and pucks. Super easy.”

3 Helpful Report

Posted 5 months ago

“I did have to elevate it a bit to get a good signal.”

2 Helpful Report

Posted 6 months ago

“It was a little difficult to install. Kept getting a blinking orange light. After a while I figured it out and it works great.”

1 Helpful Report

Posted 6 months ago

“This is perfect if you already have honeywell sensors and don't need any pucks”

2 Helpful Report

Posted 6 months ago

“The bridge was easy to install. I used it to replace my gateway puck. The bridge works so much better than the gateway puck, probably because it uses a larger omnidirectional antenna instead of a smaller directional antenna. I'm still building my system and have four vents installed on two floors in my house. The bridge improved the vent RSSI signal strength by 3 to 22 dB. On a side note, I found out that rotating the vents by 180 degrees can make up to a 10 dB difference in their RSSI.”

1 Helpful Report

Posted 6 months ago

“I thought the old way Flair worked with thermostats being able to be in bridge mode was cool, but honestly, the bridge is just better. It's range easily covers our entire 3 story house and it's been very stable. The transition from the puck bridge to the dedicated bridge took less than 5 minutes. All I had to do was go to my 2 puck bridges and set them as sensors. Everything just worked which I appreciated!”

1 Helpful Report

Posted 6 months ago