Titan Category 1, 3 Point Quick Hitch Green Reviews

4.3 Rating 249 Reviews

With the Category 1, 3 Point Quick Hitch, you can easily switch between implements that connect to your tractor's 3 Point hitch. This Quick Hitch is constructed with 3" x 3" structural steel tubing, reinforced with 9-Gauge steel gusset plates, and rated with a 3000 LB lifting capacity. Attach the 3 Point Quick Hitch to your 3 Point lift arms and easily attach or remove implements in minutes. Once connected to your tractor, connect to the 3 Point attachment using the top link hook and secure the attachment's lift pins with the locking levers.

NOTE: The quick hitch is engineered for compatibility with your Cat 1 tractor, and its front-side hooks are capable of raising an implement equipped with either Cat 1 or Cat 2 linkage pins. Please note that bushings for Cat 1 linkage pins are not provided as part of this purchase. We recommend consulting the manual for precise dimension details.

Visit Product Page

Phone:

800-605-7595

Email:

info@palletforks.com

Visit Product Page

“so far works as planned”

Helpful Report

Posted 4 years ago

“A LITTLE LIGHT WEIGHT AT A CATEGORY 1 HITCH BUT FAIR VALUE FOR THE MONEY.”

Helpful Report

Posted 4 years ago

“A great time saver for all when changing implements. If you change implements alot this is a must have product. Easy to use”

Helpful Report

Posted 4 years ago

“The hitch fit perfectly and was easy to install.”

Helpful Report

Posted 4 years ago

“Nothing is perfect. But this comes close. The only issue is the hook is a little higher and thicker than John Deere. Top hook barely fits on my box scrapper. Otherwise I like the product.”

Helpful Report

Posted 4 years ago

“So far I’m very pleased. Purchased to fit A JD 1025R. I was concerned that it would require some modification to fit my JD tiller but It matched up perfectly.”

Helpful Report

Posted 4 years ago

“i think it was very well bulit and durable and every thing is handy and priced right”

Helpful Report

Posted 4 years ago

“Works just like the real thing. I made adapters for my European mower and have not had any problems using on my new 3 Point Hitch. Used 1 1/2" hot rolled stock and bored a 55/64 hole 2 7/8" deep. Lined up the pin holes and drilled 25/64" hole through for 3/8 hardened steel bolt. Put 3 washers on each bolt with washers on both sides of adapter then placed the third between two nuts to use as a spacer to prevent the mower from sliding out of the bottom holders if the top pin should come loose. Stock, bolts, washers and nuts $17. If you have to pay for lathe time buy stock adapters.”

Helpful Report

Posted 4 years ago