I am finally able to sit down on rides and rest my legs a bit. I've been wanting to get this seat ever since it was announced. I could have built my own as others have done but I wanted the results to look like it was meant to be there rather than a bodged seat. This seat doesn't disappoint. It looks good and is a good height to make it easy enough to sit while riding. At this point, I end up sitting a bit far back and have to scoot my way up to the middle of the seat but I'm sure this is just me getting used to it. Installation was super easy. I cleaned off the trolley handle with some isopropyl alcohol, peeled the backing off the adhesive on the seat and stuck it to the handle. Simple as that. Cons: 1. The trolley handle is a bit inconvenient to release since you have to do a reach-around to release it. 2. To pick up the wheel, I now have to release the trolley handle to get the seat out of the way to get to the handle. 3. I don't think this will hold up in a crash since it is a foam seat stuck on by two sided tape. I'm also a bit skeptical that the tape is enough to hold the seat in place long term but will trust it until it fails. It Isn't something that would cause a crash if it came off so I'm not too worried about it.