I was less than thrilled with the quality of a $670 hanging lantern from Primo. Firstly, it’s next to impossible to conceal the gas line along the housing, which is a little bit of any eye sore. There isn’t any adjustment that allows the consumer to tighten the mount points while ensuring the lantern is aligned with the house. If the mounts are screwed tightly, then the lantern is at an angle to the house. This also goes for the flame tip, which comes in two pieces. Aligning the flame tip, gas valve, and routing the flare fitting such that it is straight and tight is impossible. If the gas valve is aligned to the front, which is how it should be, the flair fitting on the bottom is directed to the front, but the pre-installed 3/16” tubing is in the back. I’ve tried several times to attach pictures but always gave errors processing.